EP

January 29, 2021

C Sort Flex-Flex Couplings
The C Kind coupling consists of two flex hubs, 1 sleeve and 1 accessory kit consisting of seals and snap rings.
CFR Type Flex-Rigid Couplings
The CFR Sort coupling include one flex hub, one rigid hub, one particular sleeve, a single accessory kit consisting of seals and snap rings.
Attributes
Basic and reasonably priced type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Available as vertical and horizontal couplings
Broad assortment of particular variations like full-flex, flex-rigid mill motor
Regular configurations are available in the shelf
Ordering Details
Application: Driver and Driven.
Form and size of coupling, horizontal, vertical and so forth.
Electrical power: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Kind Couplings
Ordering Facts
Puller Holes are typical on sizes four through twelve.
Puller Holes can be found for sizes 7/8 as a result of 3.five at an extra charge.
The BSE (distance Concerning Shaft Ends) may well vary among G and G1.
Interference bores without any set screws are normal unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek the advice of Engineering Section.
Larger sizes can be found, please consult Technical Support.