EP

January 20, 2021

Power UNITS FOR LIFT TABLE 1
Standard Description
This power unit is designed solely for the tiny lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit has been extensively applied in the sector of logistic products for instance minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled by the solenoid valve together with the speed controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This energy unit is intended solely for the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve as well as pace managed by the adjustable needle valve. When the lift rises to a substantial positoin, however the energy supply is reduce, the lowering movement is controlled by the guide override function.
Electrical power UNITS FOR LIFT TABLE three
Standard Description
This power unit is developed exclusively for the massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve and also the pace controlled by a pressure compensated flow handle valve.
Power UNITS FOR LIFT TABLE 4
General Description
This electrical power unit is created solely for that big lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve along with the speed controlled by the adjustable needle valve. Once the lift rises to a large positoin, but the electrical power supply is minimize, the decreasing motion is managed by the manual override perform.
Specific Notes
one. This power unit is of S3 duty cycle, which can only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic parts concerned before set up of the energy unit.
three. Viscosity on the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
4. Oil modifying is needed following the initial one hundred operation hrs,afterwards after each and every 3000 hrs.
5. The power unit proven is created to be mounted vertically.