Electrical power UNITS FOR LIFT TABLE 1
General Description
This power unit is developed solely for that little lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit has been widely applied within the business of logistic gadgets like minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled by the solenoid valve with the pace managed through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This electrical power unit is designed exclusively for that medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as velocity controlled through the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power supply is lower, the reducing movement is controlled from the manual override function.
Power UNITS FOR LIFT TABLE three
Standard Description
This energy unit is built exclusively for that big lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the pace managed by a strain compensated flow manage valve.
Energy UNITS FOR LIFT TABLE four
General Description
This electrical power unit is created solely for the big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve and the speed controlled by the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is minimize, the decreasing movement is controlled by the guide override function.
Special Notes
one. This energy unit is of S3 duty cycle, which can only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic components concerned just before installation of the power unit.
three. Viscosity of your oil shoud be 15~46 cst,which must also be clean and cost-free of impurities.N46 hydraulic oil is proposed.
4. Oil shifting is required just after the initial one hundred operation hours,afterwards once every 3000 hours.
5. The electrical power unit shown is intended to be mounted vertically.