FHDFS Variety Floating Shaft Couplings
The FHDFS Sort coupling consists of two flex-rigid couplings and 1 floating shaft. The coupling is provided using the rigid hubs outboard except if otherwise specified. The coupling includes exposed bolts only.
Characteristics
Flex Hubs for lengthy existence
Common 20° stress angle
Heat handled bolts for better strength
Corrosion resistant bolts and nuts for ease of upkeep
Accommodates parallel and angular misalignment
Removal of center assembly enables forease of servicing without the need of repositioning machinery
Rigid hubs outboard allows for greater shaft diameters
Designed for high-torque low-speed applications that arise in mill operations
Ordering Information
Application: Driver and Driven.
Sort and dimension of coupling, horizontal, vertical and so on.
Energy: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Connecting equipment shaft sizes.
Specify which hubs are for being made use of on the products (Rigid or Flex).
Rigid hubs will probably be utilised about the products except if otherwise specified.
Length of floating shaft might influence max angular misalignment.

FMM Variety Mill Couplings
The FMM Kind coupling includes one particular normal flex hub, one particular universal straight bored hub as conventional, two sleeves and one accessory kit. This coupling is supplied with exposed bolts as conventional. Shrouded bolts are available on request by way of size five.five.
Features
For extended life
Typical 20° strain angle
Heat handled bolts for better strength
Corrosion resistant bolts and nuts for ease of servicing
Offers parallel, angular misalignment and end float
Flex Half coupling interchangeable with marketplace standards
Extended Universal Hub supplied to consumer specs with straight or tapered bores
Ordering Information and facts
Application: Driver and Driven.
Kind and dimension of coupling, horizontal, vertical and so on.
Energy: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Shaft sizes.
Taper per foot and length of taper if tapered bore is needed.
Specify counterbore dimensions if desired.
Submit a drawing if offered.