SMR Gearbox Installation
Satisfactory performance is determined by right set up. lubrication and upkeep. consequently it’s important the guidelines within the installation and servicing leaflet. supplied with each and every gearbox. are followed very carefully. a few of the vital aspects of belt and torque-arm installation are listed below.
1. Install pulley on gearbox input shaft as shut to your reducer probable, and mount reducer on driven shaft as near to bearing as useful. failure to try and do this will cause excess loads in the input shaft bearings and output bearings and could lead to their premature failure.
two. Install motor and wedge belt drive with all the belt pull at roughly 90° to the center line between driven and input shafts. this may permit tensioning of the wedge belt drive using the torque arm which ought to ideally be in tension. if output hub runs anti-clockwise. torque arm really should be positioned the appropriate.
3. lnstall torque-arm fulcrum on a rigid assistance so that the torque-arm is going to be at approximately appropriate angles to your center line through the driven shaft as well as torque arm case bolt. make sure there is certainly sufficient consider up within the turnbuckle for belt tension adjustment.
Hold near.
Bell drive can be located in any handy postion. in the event the torque arm is always to be applied to tighten the belts, the drive should be at about tight angle to the line amongst the input and output shafts.
Bell drive could possibly be situated towards the suitable if sought after.
If output hub rotates clock-wise. place belt drive and torque arm in opposite path to that shown within the illustration.
Torque arm and belt take up.
Torque arm might be mounted to the right if preferred.